Fiber optic repeater also can serve this purpose but it is not good enough, it can only function on a specific wavelength and not suitable for WDM systems.
Fiber optic amplifier is used to compensate for the wakening of information during the transmission because of fiber optic attenuation.
Used to convert long range transceivers in short range.
Fiber optic attenuator is a passive device used to reduce the amplitude of a light signal without significantly changing the wave form itself.
Third party device in between (Attenuator, Amplifier, Repeater):.
Range of the transceiver (Long, Short, Medium).
#SHOW INTERFACE ERRORS JUNIPER SERIES#
A Juniper manufactured transceiver is not necessarily compatible with EX Series Switches.
(Juniper EX Switch compatible transceivers are recommended.)
The transceiver may not be compatible with the EX Switch interface it is being inserted.
1G Transceivers will not be detected in EX4200/EX3200 SFP+ modules on interfaces 1 and 3, because these interfaces are 10G by default.
The Transceiver connected to that particular interface may not be detected due to the following:.
The particular interface may not have a transceiver installed, inserted or is not fully connected.
Interface is an Optical interface with one of the following problems: Interface Type Trunk Status Speed Neighbor If the expected Physical Interface is not listed, refer to the following possible causes:įor example, the following interface is not run show interfaces ge-0/1/0Īnd the output of the command 'show virtual-chasses vc-port' shows the configured interface is run show virtual-chassis vc-port